3 ARM與FPGA的編程控制[2]

采用硬件描述語言VerilogHDL，對LTC2207相關引腳的使能以及FPGA如何讀取采集來的數據的程序如下：

always @(posedge clk or negedge rst_n)

if(!rst_n)

begin

/OE2_2207 = 1b0;//相關引腳的軟件配置

MODE2_2207 = 1b1;

RAND2_2207 = 1b0;

PGA2_2207 = 1b0;

DITH2_2207 = 1b1;

SHDN2_2207 = 1b0;

DATA2_receive = 16d0;

state = IDLE;

done2 = 1b0;

end

else

begin

case(state)

IDLE: if(start_reg)

begin

en_9150 =1;

state = READ_DATA;

end

READ_DATA:

begin//FPGA讀取采集來的數據

en_9150 =0;

if(CLKp2_2207_reg)

begin

DATA2_receive = DATA2_2207;

done2 = 1b1;

state = IDLE;

end

else

done2 = 1b1;

end

default: ;

endcase

end

與S3C2440 GPJ1口連接的FPGA端的start控制程序代碼如下[3]：

always @(posedge clk or negedge rst_n)

if(!rst_n)

begin

start_reg1 = 0;

start_reg2 = 0;

end

else

begin

start_reg1 = start;

start_reg2 = start_reg1;

end

assign start_reg = start_reg1 (～start_reg2);

S3C2440控制啟動FPGA開始采集的start程序如下[4]：

#include

#include 2440addr.h

#include 2440lib.h

#include def.h

#include fpga.h

void delay(int a) {//延遲

int k;

for(k=0;k

}

void start(){

rGPJCON=(12)+(06); //設置I/O口GPJ1為輸出屬性，GPJ3為輸入屬性

rGPJUP=0x1fff;//禁止GPJ端口的上拉

rGPJDAT=(01);//初始化時置低電平

while(1) {

rGPJDAT=(11);//GPJ1置高

delay(50);

rGPJDAT=(01);//GPJ1置低

delay(500);

}

}